USB to RS485 Interface Converter

The USB-2-RS485 device is an USB to RS485 interface converter. It adds a standard 2-wire half-duplex RS485 bus interface to computers with USB interface.
The USB-2-RS485 device is an USB to RS485 interface converter. It adds a standard 2-wire half-duplex RS485 bus interface to computers with USB interface.
This device is supported by all major operating systems: Windows, Linux, Mac OS X and Android.
A virtual COM port driver is included, that is, the RS485 interface can be accessed as a standard serial COM port e.g. using any terminal program like HyperTerminal (supplied with all versions of Microsoft Windows).

RFID nfc reader ufr

 TECHNICAL DATA

  • USB
    • Connection to USB 1.1 or USB 2.0 hosts possible
    • USB full speed device (12MBit/s)
    • Bus powered (no extra power supply needed)
  • RS485
    • Half duplex communication mode
    • No loopback (receiver is switched off while transmitter is active)
    • 120 Ω termination resistor
  • HOUSING
    • Plastic housing
    • Plastic housing

 DRIVER INSTALATION

USB to RS485 device uses the FTDI chip drivers which can be obtained at: http://www.ftdichip.com/Drivers/D2XX.htm
After installing the FTDI drivers the device is registered as USB Serial Converter.
For additional information and technical support write to us at: This email address is being protected from spambots. You need JavaScript enabled to view it.